Tonight Phil’s topic was a three legged bowl and a three winged bowl, the first was turned from a piece of sycamore cut into an equilateral triangle (60 degree angles). This piece measured about 8cm in depth and 15cm across.
Next the centre was marked and a hole drilled to mount the piece on a screw chuck. Most of the work done on this piece was using a bowl gouge with occasional use of a spindle gouge. The lathe was run as fast as Phil could safely turn on it. The first job was to remove the outside points of the triangle to form the shape where the three legs will be, once done the face was flattened and some of the material on the inside of the legs was removed. A tenon was then turned on the base before finishing shaping the inside of the legs and the outside of the bowl. This was then sanded – Phil showed us how to mount some Abranet sanding material onto a firm foam block to enable you to sand inside the legs and being able to keep your fingers well out of the way of the legs. Mark a centre on the tenon for later use.
Once done the piece was removed from the screw chuck and remounted in the chuck jaws using the tenon. The outside of the legs were then shaped ensuring the gouge used has been freshly sharpened and that a nice shape was achieved. Once the shape has been created the inside of the bowl was hollowed out and sanded to finish it off.
The bowl was now reverse mounted on a disc with a rubber mat (you can use a jam chuck) to enable you to remove the tenon and tidy up the base of the bowl, this was then sanded.
These second piece Phil demonstrated was a three winged bowl made from a cube of Walnut that was about 15cm x 15cm x 15cm in size. The first part of the process was to flatten two opposite corners of the cube to enable the piece to be mounted between centres, the lathe was slowly brought up to speed to ensure the cube did not come loose. On the tailstock end a tenon was turned to allow the piece to be mounted in the chuck jaws, the spare material below the tenon was turned reduced to a safe thickness and then once the lathe had been stopped cut off with a saw, mark the centre for potential later use.
The piece was then turned around and mounted in the chuck jaws, it was supported with the tailstock and the bottom of the bowl was shaped, Phil did warn us to take care as the points on the cube can cause some pain if they catch your fingers! Some of the weight from the top of the bowl was removed whilst maintaining support from the tailstock as long as possible.
The tailstock was then removed and the bowl shape developed whilst aiming for an even thickness for the legs and bowl edge. The bowl centre was then removed and the finish refined by sanding. Phil stopped to check the shape, thickness on a regular basis to make sure he got the shape he was after.
Once done the piece was reverse mounted on a dome jam chuck using (if he had it with him some router mat) a padding material to protect the inside of the bowl and held in position with the tailstock. the bottom of the bowl was tidied up giving it a concave base, this was then sanded to give it a smooth finish.

















