Author: srdm1207gmailcom

This evening’s Show and Tell was a very interesting and illuminating meeting where novice and more experienced members shared their recent projects with the rest of us. Russell kicked off the session by introducing Alan Pattison who had made two birds – following the theme for the night which was to make a figure or an animal.

Contributions from Robin, Alan Jones and Mark took us to the break.

After tea we heard Brian’s anxiety about the bowl he’d made from a piece of wood “that he had paid good money for”. Roger explained his methods in making a variety of items followed by Russell’s own projects

The contribution of the evening came from Dexter – a young man who had largely taught himself to turn from YouTube videos. His progress has been remarkable as everyone can see. Let’s hope we see more of him in the future.

Hollowform by Alan Edwards

Tonights demo was due to be held by Geoff Davies but unfortunately he was too unwell to hold it. Everyone at the club wishes you a speedy recovery Geoff.

So Alan stepped up with only a few hours notice to undertake this interesting hollowing demo. Using a 3″ Zebrano disk he began by rounding it and putting a spigot on either end – one of which would later serve as the foot.

Having roughly shaped the outside Alan then offered us an alternative that he had previously made – the same vessel with circular insets using his home made jig to house the Forstner bit and utilising the lathe’s indexing.

Time now to part the vessel in half and hollow leaving a lip in order to rejoin the two halves later. Once glued with Superglue he set about the final shaping including finishing the foot and applying a thinned down coat of melamine (3-2)

The foot now served as the spigot to reverse the vessel, complete the opening with his spindle gouge, and finish.

A really good and interesting project, especially considering the short notice he had. All our thanks go to Alan.

Turned Candlestick with Inside Out Centrepiece

Tonight the club welcomed accomplished turner and demonstrator Robert Till to Droitwich. His chosen project was a turned candlestick incorporating an inside out element as it’s centrepiece. He began by showing us how to glue 2 pieces of shop – bought pine together and mark up his intended design.

Having executed his design using a spindle gouge he parted the 2 pieces – reversed them and then re – glued.

Using a series of beads and coves Robert completed his spindle before separately turning a base for the candlestick.

Thanks to Robert for a very clear and concise demonstration.

The club organised a couple of all day sessions using some of our newly – qualified lathe leaders where new members, in particular, were able to enjoy some 1 to 1 tuition in the basics of woodturning.

As usual on our Hands On evenings we get out our 4 club lathes for members to have a go under the watchful eyes of our lathe leaders. The project set tonight was to make a needle case and a number of members, new and not so new, tackled the task.

A number of people completed the task. Well done everyone!